Aaron, List,
Below is a copy of an answer to same question of Vance some 6 months ago.
Pics again will be stripped...
Cheers,
Marc
----- Original Message -----
From: "Marc Nederkoorn" <adsl709847@tiscali.nl>
To: <m_girardin@sympatico.ca>; "Jay Snable" <jsnable@mac.com>; "Navarrette,
Vance" <vance.navarrette@intel.com>
Sent: Thursday, February 09, 2006 11:26 PM
Subject: J-Type OD conversion pump cam clips
> To Vance, Marc, Jay and interested listers:
>
> I think the recently discussed Spring Clip, and I did find it in the
> Rimmers
> catalog:
> See
> http://www.rimmerbros.co.uk/rimmer/triumph/tr6/overdrive-J
>
> 16. Spring Clip (around mainshaft) - (1) - 159503
>
> has a very straightforward use: it covers a groove in the OD mainshaft
> thus
> compensating for the indent. And the groove is needed for machining the
> shaft: Otherwise you cannot cut the splines. I think the clip eases
> mounting
> the OD on the mainshaft and beyond that has no function. If you already
> have
> mounted the OD and discover this particular part still on the workbench
> not
> to worry. Of course thats just my opinion but from Vance's perspective: I
> wouldn't loose any sleep on this one!
>
> I have attached pictures of the Spring Clip mounted for those who asked
> already. The 'Clips1' pic shows both clips, I marked them. The 'Spring
> Clip'
> pic is somewhat blurry but is a close-up of the spring Clip and that part
> is
> clearly visible.
> As the list will have stripped the attachements just give me a note
> off-list
> and I will send the pics.
>
> Regards,
>
> Marc
[demime 1.01d removed an attachment of type image/jpeg which had a name of
Spring Clip.jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
Clips1.JPG]
|