6pack
[Top] [All Lists]

Re: [6pack] Correction New springs - Help!

To: richard.r.olson@faa.gov, 6pack@autox.team.net
Subject: Re: [6pack] Correction New springs - Help!
From: Greg Perry <rgperry@earthlink.net>
Date: Mon, 22 Oct 2007 18:45:28 -0500 (GMT-05:00)
Rick,

Correction: Change the word Vertical to Horizontal in the paragraph below
Sorry,  Greg Perry

-----Original Message-----
>From: Greg Perry <rgperry@earthlink.net>
>Sent: Oct 22, 2007 5:22 PM
>To: richard.r.olson@faa.gov, 6pack@autox.team.net
>Subject: Re: [6pack] Fw: New springs - Help!
>
>Rick,
>
>The lower control arm needs to be vertical with respect to the ground.  This 
>will give you access to the inner nuts.  With the weight of the car supported 
>with a jack stands on the frame, I use a section of 2" x 4" to support the 
>control arm under the trunnion so that the arm is about vertical.  Greg Perry
>
>>Q2  -
>>The bigger only - The spring pan, my tool with a 1" X 3" alum, 1/2"
>>threaded, nuts and the spring is IN
>>but not much compressed.  But I can't get the 2 nuts on the inner sides
>>(close to the frame).
>>
>>How can I do this?
>>
>>Thank,
>>Rick Olson ("being carefull!")




<Prev in Thread] Current Thread [Next in Thread>
  • Re: [6pack] Correction New springs - Help!, Greg Perry <=