Darcy
Just a question, did you use pilot bolts to support and direct the
transmission in place upon your last assembly?
Dale
________________________________
From: "Hunter, Darcy"
<Darcy_Hunter@Instron.com>
To: "6pack@autox.team.net" <6pack@autox.team.net>
Sent: Tuesday, May 26, 2009 2:37:37 PM
Subject: [6pack] Clutch/Transmission
issue
Thanks Kendall, I did go out to the garage last night and used a pry
bar to
check the end float. Did not use a mic but by feel, didn't detect
anything
measureable so I'll put that in the column of reviewed but not
probable.
Darcy
Subject: Re: [6pack] Clutch/transmission Issues
To:
Darcy_Hunter@Instron.com, 6pack List <6pack@autox.team.net>
Message-ID:
<82363.6514.qm@web82608.mail.mud.yahoo.com>
Content-Type: text/plain;
charset="us-ascii"
Hi Darcy,
The last time I had the symptoms that you
describe... I had lost the thrust
washer at the rear main bearing. And the
reason the clutch stopped working
properly is because the whole crankshaft had
about a 1/4" of travel front to
back. I let it go too long before I discovered
the root cause and ended up
with a messed up crank and block. Not cool.
Hopefully not your problem, but
you should definitely check the end float
before trying anything else.
Kendall
Camarillo, CA
_______________________________________________
Support Team.Net
http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You
are subscribed as tpdwinch@yahoo.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|