Thanks Bill
In a message dated 9/30/2010 4:32:41 PM Eastern Daylight Time,
william.mcintire@wright.edu writes:
I believe the 2,3,4's had a return spring on the slave cylinder. This
would cause the SS piston to return to its 'home' position wherever that was.
The adjustable push rod was needed to maintain proper clearance between the
TO bearing and PP. The rods on the 6 just sort of float out there and
clearance between PP and TO is minimal. Adjustable rod on the 6 will make no
difference unless a return spring is attached to the clutch release arm as in
TR4. At least that's how I remember it and the more time that goes by the
bigger the memory ? becomes.
Bill
'70 6 original owner
----- Original Message -----
From: Sally or Dick Taylor <tr6taylor@webtv.net>
Date: Thursday, September 30, 2010 4:15 pm
Subject: Re: [6pack] Clutch slave pushrod
To: Vsnively@aol.com, 6pack@autox.team.net
> Vic---I don't know what the SC differences are between the four
> and the six, but the Triumph factory must have felt the self
> adjusting later design was better. The later SC, with its
> internal spring, keeps all of the play out of the linkage
> between the SC pushrod up to the clutch fingers. Apparantly the
> TR4 needed to have this rod adjusted when play developed in the
> clutch mechanism. No such adjustment is needed with the
> six. However, if there is play in the linkage down in the
> pedal box, it must be corrected to get the full stroke of the
> clutch pedal. (The adjustable pushrod will not get back this
> lost motion).
>
> The question might be: Would the later SC be a better choice for
> the TR3/4? (I don't know the bore size, bolt flange dimension, etc.)
>
> Dick
> _______________________________________________
>
> 6pack@autox.team.net
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/6pack/william.mcintire@wright.edu
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/6pack/vsnively@aol.com
_______________________________________________
6pack@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|