autox
[Top] [All Lists]

adj. swaybar endlinks

To: mshields@inconnect.com, autox@autox.team.net
Subject: adj. swaybar endlinks
From: TeamZ3@aol.com
Date: Wed, 11 Aug 1999 19:37:26 EDT
mshields@inconnect.com writes:

<< 
 Since most stock class cars cannot be adjusted to compensate for driver 
weight
 on corner weights and the fact the driver is in the car will cause turns to 
the
 right to be less effective than turns to the left (due to more roll in the 
first
 case), could an asymetrically adjusted bar be used to compensate for this?
  >>

I stated this in the original response way back when, the answer is it can be 
done, dependent on the actual corner weight conditions that exist, by 
preloading bar torsion via adjustable end links.  The effectiveness of 
preloading the bars is dependent on the same principles of corner weighting; 
increasing the weight on one corner also increase the weight on the opposing 
diagonal corner, while lightening the other opposing diagonal corners; none 
of which will be directly proportional.  However, unlike with corner 
weighting you have no effective way to raise or lower one end of the car 
equally with adj swaybar endlinks to address front/rear balance.

Now if the case of both corners on the same side of the car having higher 
weights than the other side, you're *potentially* SOL in the Stock class 
because you can only convert to the adj end links on the front bar (legally). 
 In this situation if you try to balance the front corners using the adj 
front endlinks you'll also create more bias to heavier side of the rear 
corner in the process.  Now you can really enter some serious tuning games if 
you know how to potentially overcome the skewed rear weight bias using other 
methods; different tire pressures side to side, etc. but your entering really 
deep territory in which to bury yourself in the mire of confusing 
ramnifications.  Why balance the front and have to deal with resulting 
problems in the rear?  On certain vehicles the limiting factor is front 
turn-in and bite through the corner.  If you can resolve that issue and have 
other legal methods to negate the resulting rear bias issues then you can 
potentially create a significant handling performance gain for that vehicle.

That's the *joy* of Stock class racing; using unconventional ideas and 
methods to resolve handling issues because the conventional methods aren't at 
your disposal as a result of the rules.

M Sipe
 - there's nothing like the smell of a freshly opened can of worms!

<Prev in Thread] Current Thread [Next in Thread>
  • adj. swaybar endlinks, TeamZ3 <=