Re: Engine and gearbox vibration/noise

[garnett@theory.TC.CORNELL.EDU (Roger Garnett)]

On Oct 10,  8:36am, Philip J Ethier wrote:
 
} driveshaft above axle and pull it out.  Now try to put it back in!  Factory
} book said the guy at the rear does the work, the guy at the front just lines
} it up with a screwdriver through the dime-sized hole for greasing the U-joint.
} Right.  Lucky for us, some previous owner had enlarged that hole to hand-size.

The "racing modification" is a cutout on the bottom side of the
car. This allows easy access for feeding the spline on the driveshaft
into the hole in the tranny.

Roger