Re: removal technique, brake brace stud, Roadster Bar-B-Q

["SlowBoy" <slowboy@cox.net>]

If it was welded I'd remember due to the amount of swearing I would have 
done. Mine was a1970.

I wanted to keep the original stud so I put a rubber mallet on the end of 
the stud and smacked it with a hammer.

----- Original Message ----- 
From: "Fergus OFarrell" <fergus06@socal.rr.com>

> Is the lower brake master cyl stud tack welded to the body, or is threaded 
> in?
> Is the suggested way to remove the brake master, then give the stud a
> short-sharp-shot,