fot
[Top] [All Lists]

Re: Axle quotes

To: fot@autox.team.net
Subject: Re: Axle quotes
From: R John Lye <rjl6n@uva.pcmail.virginia.edu>
Date: Fri, 20 Jun 97 14:07:51 EDT
On Jun 20, 12:57pm, Chip Bond wrote:
> in a previous contact. If they do, are any of you willing to double your 
> order?

I'd have a tough time justifying it myself, but if that was the only
way to get them...

> Is the cost acceptable?

Yup, its still cheaper than the alternative.

> Does anyone have comments about "through hardening" and the E-4325 alloy?

Sorry, you're out of my league here.

> If any of you would like a copy of the drawing I'm using for quotation 
> request, send your fax number.

I'd like to get a copy, mostly for my own curiousity.  My fax
number is 804-589-3909.  Thanks.

Once again, thanks for taking on this project, Chip.

John Lye

rjl6n@virginia.EDU
http://avery.med.virginia.edu/~rjl6n/homepage.htm

<Prev in Thread] Current Thread [Next in Thread>