RE: Barking Heads

["Randall Young" <ryoung@navcomtech.com>]

> There's a good chance your guides were too tight to begin with--it's
> worthwhile to run the correct size ream through them before assembly (not
> a 5/8 drill bit).

Bill, I'm curious as to why you say to do this before assembly, rather than
after.  I've heard that the bronze TR guides tend to distort as they are
installed, and need to be reamed after installation ?   Certainly mine
seemed to close up after installation, but I didn't measure them carefully
beforehand.

Randall