[Top] [All Lists]

RE: Barking Heads

To: "'Randall Young'" <>,
Subject: RE: Barking Heads
From: Bill Babcock <>
Date: Mon, 15 Sep 2003 12:19:15 -0700
I didn't mean before you install the guides, rather before you install the

-----Original Message-----
From: Randall Young [] 
Sent: Monday, September 15, 2003 11:36 AM
Subject: RE: Barking Heads

> There's a good chance your guides were too tight to begin with--it's 
> worthwhile to run the correct size ream through them before assembly 
> (not a 5/8 drill bit).

Bill, I'm curious as to why you say to do this before assembly, rather
than after.  I've heard that the bronze TR guides tend to distort as they
installed, and need to be reamed after installation ?   Certainly mine
seemed to close up after installation, but I didn't measure them carefully


<Prev in Thread] Current Thread [Next in Thread>