In my never ending quest to never toss anything I am trying to rescue a TR4
block that I got without main bearing caps. I have spare caps for the front
and center caps that are close enough for line honing but not a rear cap. My
machinist suggested that I could get a cap modeled and CNC'd to fit. We
talked about whether there would be anything gained from billet caps all
around. Has anyone done this?
Bob Kramer
Austin, TX
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|