The pad is installed in a recess between the adapter bell and the gearbox, so
you do need to separate the bell. The recess in the bell is for clearance for
the shifter rods.
Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC USA
----- Original Message -----
From: ggilliam@usol.com
To: BJ8Healeys ; rdavies1@cox.net ; Healeys Mailing List
Sent: Saturday, August 21, 2004 8:40 PM
Subject: Re: bj8 locking in first: to pin or not to pin, that is the
How is this pad installed? Does the transmission need to be separated
from the adapter bell, can it be done "in-situ"?
Thanks,
Gordy
> Yes, the parts list (AKD 3523) shows the pad. It is Pad - Buffer,
part number
> AEC 3298.
>
> Steve Byers
> HBJ8L/36666
> BJ8 Registry
> Havelock, NC USA
> ----- Original Message -----
> From: Ron Davies
> To: BJ8Healeys ; Healeys Mailing List
> Sent: Saturday, August 21, 2004 10:07 AM
> Subject: RE: bj8 locking in first: to pin or not to pin, that is the
> question
>
>
>
> "I could see the problem was that the rods were moving too
> far forward. Putting a pad cut from linoleum into the shifter rod
recesses
> fixed it."
>
> ___________________
> Steve,
> Do any parts or service manuals show this pad or is it something
we just
> learn from experience?
> Ron
> 37444
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|