healeys
[Top] [All Lists]

Re: Fuel Gauge problem

To: "Paul Baker" <paulbaker51@yahoo.co.uk>,
Subject: Re: Fuel Gauge problem
From: "Chris Dimmock" <cd3000@bigpond.net.au>
Date: Sun, 3 Apr 2005 08:35:24 +1000
Hi Paul,

I'm guessing that you decided which direction to fit  the sender unit based 
on the external location of the electrical contact. You can't - it has to be 
based on the direction of the float.

Remove the sender unit from the tank, and rotate it 180 degrees, and refit.

The float needs to sit in the recessed section of the tank - the 
semicircular 'channel' - which is lower than the rest of the bottom of the 
tank - to get an accurate reading on low fuel. If the sender unit is 
installed 180 degrees out, the float sits on the flat bottom of the tank, 
and won't read much below half/ quarter of a tank - and then you run out of 
fuel....
Best

Chris

----- Original Message ----- 
From: "Paul Baker" <paulbaker51@yahoo.co.uk>
To: "austin healey" <healeys@autox.team.net>
Sent: Sunday, April 03, 2005 4:08 AM
Subject: Fuel Gauge problem


> The fuel guage in my BJ8 will now only read just under half full as the 
> minimum reading.
>
> When switched off the guage reads zero and when I took the sender unit out 
> and turned on the ignition it read full so assume the guage is ok.  The 
> float does not appear to be punctured and the arm moves freely.  The arm 
> inside the sender unit appears to contact the winding mechanism across the 
> full length and the contact seems clean.
>
> Is now the time to replace the sender unit or is it something else?
>
> Paul Baker
>
> 66 BJ8
> 67 BJ8




<Prev in Thread] Current Thread [Next in Thread>