healeys
[Top] [All Lists]

Re: Looking for static

To: "John O'Brien" <banjojohn@cox.net>,
Subject: Re: Looking for static
From: "Alex" <alexmm@adelphia.net>
Date: Fri, 3 Jun 2005 09:20:17 -0400
John:

Just run your radio when you're parked and your problems will be over.    (hee
hee)

Seriously though, you might also want to re-locate the car's antenna to the
rear deck. Also, have you checked the feed cable for continuity of the coaxial
cable's outer shield? Is the inner conductor making good contact? Check for a
short between the inner conductor and the outer shield, too.

You didn't say how far away from the FM stations you are located. You may just
have weak signal strength. It's also possible that your FM radio has a
defective RF amplifier stage (internally).

Good luck!

==    Alex in Maine, Amateur Radio AI2Q
      1960 BT7 3000 Mark 1 - "The Blue Mainie"
      Former owner of 1957 100-6, and 1967 3000 Mark III BJ8
      http://users.adelphia.net/~alexmm/ai2q.htm

  ----- Original Message -----
  From: John O'Brien
  To: Healey List
  Sent: Friday, June 03, 2005 8:05 AM
  Subject: Looking for static


  Hi List:

  I'm looking for static, and I know the list is just the place to help me
  find it.   In my BJ8 I get a lot of static in the radio, both am and fm.  I
  have converted the car to neg. ground. The wires and plugs are supposed to
  be radio friendly (not produce static) I have a Radio Shack noise filter in
  the power wire to the radio and even put in a relay so the power to the
  radio comes directly from the battery rather than from anywhere having to
do
  with the ignition.  I also have a Pertronix unit that eliminated the
points.
  Still got static on all but the strongest stations.  Should I be
  checking/replacing the rotor and or Dist. cap?  Where else should I be
  looking for the problem.

  Thanks for any advice.

  John O'Brien
  '61 Bugeye
  '65 BJ8




<Prev in Thread] Current Thread [Next in Thread>