healeys
[Top] [All Lists]

Re: Please ... help with this question about starter

To: <healeys@autox.team.net>
Subject: Re: Please ... help with this question about starter
From: "BJ8Healeys" <sbyers@ec.rr.com>
Date: Fri, 12 Aug 2005 15:59:39 -0700
Hi, Alan -

Sometimes you can add some washers/shims of the right thickness under a nut to
get the nut castellations and the split pin hole to line up closer.  At least
then you don't have to over- or undertorque the nut so much.

Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC  USA
  ----- Original Message -----
  From: Alan F Cross
  To: tomfelts@earthlink.net
  Cc: healeys@autox.team.net
  Sent: Thursday, August 11, 2005 9:02 AM
  Subject: Re: Please ... help with this question about starter
motorre-assembly!


  Mine I have to back off nearly a quarter of a turn to get the split pin
  in. Suppose I could try and wrench it on a bit tighter, to get to the
  next slot.


  In message <410-22005841116855520@earthlink.net>, tom felts
  <tomfelts@earthlink.net> writes
  >Not saying this is right, but I have installed several BJ8 starters and
  >never "caulked" the nut you refer to.  It is too tight (IMO) to rattle.
  >
  >
  >> [Original Message]
  >> From: Alan F Cross <alanx@proaxis.demon.co.uk>
  >> To: <healeys@autox.team.net>
  >> Date: 8/11/05 10:09:16 AM
  >> Subject: Please ... help with this question about starter
  >motorre-assembly!
  >>
  >> Hope you guys don't mind me asking this starter motor question again,
  >> but I had no responses! Has it got y'all stumped, or is it just a crazy
  >> question? I really don't want to guess and re-install wrongly.
  >>
  >> Manual says "NOTE: When reassembling the starter drive, the locating nut
  >> must be re-caulked to the armature shaft."
  >>
  >> I presume the 'locating nut' is actually what the manual calls the Shaft
  >> Nut that is locked with a split pin. I'm guessing that, as this can only
  >> be tightened to the nearest split pin hole, it needs to be 'gummed up'
  >> to stop it rattling. Am I anywhere near the truth?
  >>
  >> If I'm right, what is it that I use to do the caulking? Something
  >> special, or a spot of bathroom silicone sealant?
  >>
  >> Even my supplier Steve, at Cape, is at a loss on this!
  >>
  >> Thanks again, as ever.
  >> --
  >> Alan F Cross (H-BJ8-L/41672 aka "Ginny")
  >> Webmaster for the UK's national Austin Healey Club at:
  >> http://www.austin-healey-club.com
  >
  >
  >

  --
  Alan F Cross BSc LRPS - Heathfield Studios
  Photographic Restoration - Digital Photography - Web & Graphic Design
  'Heathfield', Heathlands Road, Wokingham, Berkshire, RG40 3AR, UK.
  T/F: +44(0)1344 751125 - www.heathfield-studios.co.uk




<Prev in Thread] Current Thread [Next in Thread>