> Gary, I read Traf. green/blue goes to green/red in harness. Traf.
> green/yellow goes to green/white in harness. Traf. green goes to
> green/brown in harness.
> And Brown/Black in Traf. goes to Purple/black in harness.
>
> This is out of the serv. manual for Later Healeys.
>
> Mark
>
> ----- Original Message -----
> From: <GSFuqua1@aol.com>
> To: <healeys@autox.team.net>
> Sent: Saturday, December 17, 2005 8:48 PM
> Subject: Double EE or Electrical Exasperation!!
>
>
>> You know, after you have done several you think you have things sorted to
>> some degree but then along comes the electrical gremlins and total
>> exasperation.
>>
>> I just rewired an early model BJ8 (64) and can't get the turn signals to
>> hook
>> up correctly. I have gone back over the wiring several times checking to
>> make sure colors are correct etc. Everything looks good until I get to
>> the wires
>> coming out of the main harness and the ones coming out of the new
>> trafficator. No matches. I have the brown with black from the
>> trafficator going to the
>> purple with black from the harness. That is the horn. From there it is
>> straight down hill. From the trafficator I have a green with white
>> stripe and a
>> green with red stripe. I am assuming they just plug directly into their
>> corresponding counterparts on each turn signal. That leaves me with a
>> green with
>> brown coming out of the trafficator and 3 wires from the harness. A
>> green wire
>> (Hot), a green with yellow and a green with blue. No matches. What am I
>> missing here??
>>
>> Going crazy in Branson,
>>
>> Gary
|