Hi Tracy
2 choices:
Weld up the oblong holes; and then redrill them round so the new clevis pin
is a snug fit, and grease it.
Alternatively - buy new rods, and grease the clevis pins before fitting.
best
Chris
----- Original Message -----
From: "Tracy Drummond" <bighealey@charter.net>
To: <healeys@autox.team.net>
Sent: Wednesday, August 23, 2006 10:28 PM
Subject: Oblong clevis pin holes in pedal box
>I have an oblong hole where the master cylinder rod attaches to the foot
> pedal. I replaced the clevis pins in both the brake and clutch pedals but
> alas still some play on the one causing annoying little thumps when the
> clutch engages and another (often delayed) when released.
|