healeys
[Top] [All Lists]

Re: [Healeys] Proper starting procedure for a BJ8

To: "Rich C" <richchrysler@quickclic.net>
Subject: Re: [Healeys] Proper starting procedure for a BJ8
From: "Alan Seigrist" <healey.nut@gmail.com>
Date: Tue, 1 Jan 2008 20:54:44 -0800
Jorge -

You should do as Rich suggests - but I might suggest beforehand to first try
to manually hold up both choke levers in the full up position with your
fingers on the carbs while someone cranks the car over.  I've done this a
number of times and it starts every time.  Much better than dumping starter
fluid in there.  If it doesn't start when you do that, then it will likely
be something else like a bad dizzy rotor or something.

Best Regards,

Alan
'52 A90
'53 BN1
'64 BJ8
On Jan 1, 2008 8:37 PM, Rich C <richchrysler@quickclic.net> wrote:

> Jorge,
>
> I stand by my first suggestion. Did you remove the upper chambers and
> pistons, and pull the choke cables out fully, then look down into the
> carbs
> to observe how much the jets are actually pulling down? I'd bet they
> aren't
> moving down far enough to allow a rich enough mixture.
> Also, with the choke cables fully pulled out, try moving the choke levers
> manually to see how much further they could actually drop the jets. With
> the
> levers pulled up manually to their extent (and the carbs reassembled,
> she'll
> probably start. There is often either lost motion in the lever to cable
> linkages or a maladjustment of the fast idle levers and where they seat.
>
> Rich Chrysler
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>