Thanks, David. It is rather disappointing to hear that Heritage's foam is
no better than Moss'. Perhaps they use the same supplier . . . The
situation you describe sounds exactly like what I observed at the show.
Sounds more and more like I'll use Raul's shop.
Bruce Steele
1960 BN7
Brea, CA
----- Original Message -----
From: "David Schweninger" <quenty@ntelos.net>
To: "Healey Bruce" <healeybruce@roadrunner.com>; "Ron Fine"
<RonFineEsq@earthlink.net>; "Healey Mail List" <healeys@autox.team.net>
Cc: "David Schweninger" <quenty@ntelos.net>
Sent: Monday, June 09, 2008 4:49 PM
Subject: Re: [Healeys] Seat pans
> Bruce,
> I bought re-pro seat pans from David Homonek (on Ebay) which seem to
> fit the seat frames pretty well.
>
> There is an on going problem with the molded seat foam parts.
> Apparently Moss has the same problem
> I bought a complete Heritage Interior. The seat foams are not molded
> correctly. If you fit the foam into the seat pan so it fits correctly
> across the front, there is about a 1 1/2 gap at the back. If you pull
> the cover down over and under the seat pan you'll have about a 1 to 2
> " gap.
> Heritage is well aware of the problem. I guess new tooling for the
> seat foam is too expensive.
> So their recommendation is to stuff whatever you have handy into the
> space until the gap is filled.
> I glued a piece of foam across the back of the seat foam and then
> slowly trimmed the sides until the cover fit properly.
> The next problem was that the pleats and the bolster w/piping was
> not sewn together far enough back. Allowing the the foam to show.
> Sewing this by hand is a real bitch. Check this out before you glue
> the cover pleats down
> Also the Heritage instructions say to use "supplemental" foam on
> the bolster. When I pointed out that it was not furnished in my kit. I
> was told "we don't use that any more".
> This means the pleats are as high or higher than the Bolster. I added
> a 1/2 thick piece on top of the bolster.
> I've attached some pictures which may help.
> Good luck,
> Dave and Daisy ( Who has nice round Bolsters)
>
>
>
>
>
>>
>>
>
--------------------------------------------------------------------------------
>
>
--------------------------------------------------------------------------------
>
>
>
--------------------------------------------------------------------------------
>
>
>
--------------------------------------------------------------------------------
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|