healeys
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

[Healeys] Pop rivet Question

from [Mark LaPierre] [Permanent Link][Original]
To: <healeys@Autox.Team.Net>
Subject: [Healeys] Pop rivet Question
From: "Mark LaPierre" <lapierrem@sbcglobal.net>
Date: Tue, 21 Apr 2009 04:16:59 -0400 
Its time to install the rear shroud.   Since this is an allum. to steel metal
connection area
would  SS  pop rivets be a reasonable choice for this area to cut down on the
corrosion
problem?   Or are the allum. pop rivets OK to use?

No  Conco??????  here mates,    I can't even spell the word with out getting
points knocked
off.     Gees

Mark
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  [Healeys] Where Does it Go? Question, Mark LaPierre
Next by Date:  Re: [Healeys] Pop rivet Question, Alan Seigrist
Previous by Thread:  [Healeys] Where Does it Go? Question, Mark LaPierre
Next by Thread:  Re: [Healeys] Pop rivet Question, Alan Seigrist
Indexes:  [Date] [Thread] [Top] [All Lists]