mirek ... Factory service bulletin # 37 Oct 1962 You will find a copy of
this in Austin Healey Magazine June 1996 OR page 149 in my Tech Talk
Book .. Thie Bulletin shows a drawing 3/8" from end of outer cable to end
of inner cable at speedo end ... Norman
Nock.
--- On Sat, 8/8/09, Mirek Sharp <m.g.sharp@sympatico.ca> wrote:
From: Mirek Sharp <m.g.sharp@sympatico.ca>
Subject: Re: [Healeys] Speedo Cable and the washer
To: "Bob Johnson" <bjsbj8@gmail.com>, "john spaur" <jmsdarch@sbcglobal.net>
Cc: "Healeys" <healeys@autox.team.net>
Date: Saturday, August 8, 2009, 3:55 PM
Nisonger say the correct protrusion of the inner cable at the speedo head is
7/16".
Mirek
----- Original Message ----- .... I am not sure what the correct penetration
should be though.
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as sjnnock@sbcglobal.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|