healeys
[Top] [All Lists]

Re: [Healeys] Lights & loom query

To: "'Rich C'" <richchrysler@quickclic.net>, <healeys@autox.team.net>
Subject: Re: [Healeys] Lights & loom query
From: "Simon Lachlan" <simon.lachlan@homecall.co.uk>
Date: Wed, 9 Dec 2009 12:34:38 -0000
Rich,
Thank you very much indeed for this.
Yes, my car is Mk2 BT7.
Simon.

-----Original Message-----
From: Rich C [mailto:richchrysler@quickclic.net] 
Sent: 08 December 2009 23:31
To: Simon Lachlan; healeys@autox.team.net
Subject: Re: [Healeys] Lights & loom query

Simon,

For others' information I believe you have a MK 2 BT7  ??

The wiring from the stator tube comes out of the tube and goes up to plug 
into the four Lucas tube/bullet connectors of the main harness. These should

be located in the immediate vicinity of just under the sliding bonnet latch 
assembly. As the stator wiring goes across the X brace in front of the 
radiator, a single barbed clip with a raised semicircle relief clips the 
harness to the X brace very near the middle of the X.

Main front loom to side lights. I already sent you pics of the location of 
the right and left main harness plug-ins for side and head lamps. The wiring

coming out the back of the sidelamp boot is wrapped back along side the 
cylindrical body of the boot where an "O" ring is rolled over boot and loom 
to keep it tight to the boot ansd away from the front tire. From there the 
side lamp wiring goes inboard, under and forward of the inner wing splash 
panel where it then goes up and plugs into the main forward harness.

Head lamp wires (high beam, low beam and black earth wire) are plastic 
coated and are braided together from where they exit the headlamp pot.These 
braided loom goes up and over the top of the iner wheel arch. A barbed 
spring clip holds them to the top flange of the inner wheel arch. Once 
inboard, they plug into the main forward harness.

Rich Chrysler

----- Original Message ----- 
From: "Simon Lachlan" <simon.lachlan@homecall.co.uk>
To: <healeys@autox.team.net>
Sent: Tuesday, December 08, 2009 4:18 PM
Subject: [Healeys] Lights & loom query


> Some time, sooner or later & very probably much later, my front grille 
> will
> return from the chromers(?). I shall then be able to put the car back the
> way it was or should have been.
> So, I previously asked you for and obtained info regarding the general
> layout of the loom as it passed around the front of the car.
> Now I 'd like to know about the specific routing of
> the wire from the loom to the stator tube
> the wires from the loom to the side lights
> the wires from the loom to the head lights.
> ie are they clipped up to something and to what, where?
> Do they drop down from the loom straight away and take a low path? Or, do
> they stay high and drop down to the lights at the end of their travel?
>
> Mine were a complete dog's breakfast tied on with plastic cable ties and 
> I'd
> not want to do that again.
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>