You can now find this complete with photos in the "Body" section of the
Technical page on my site. Thanks, Patrick.
John Sims, BN6
Aberdeen, NJ
http://www.healey6.com
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Patrick Yoas
Sent: Sunday, April 25, 2010 4:05 PM
To: Healey Forum
Subject: [Healeys] under dash insulation pad
Tom,
I received my Jule Frame and it required me to put in my own "captive nuts".
After tossing around a few ideas I came up with the following solution:
I purchased 10/32 T-nuts and flattened their barbs. I drilled the holes and
the drill size I used allowed for a very tight fit. It was tight enough that
I
didn't need to have someone assist me in installing them. I did this for the
insulation panels I installed because it gave me a near flat profile so I
wouldn't have bumps under the carpet. I plan to silicone seal the T-nuts to
insure water tightness. I have pictures but can't post them on this forum so
let me know if you would like to see the results?
Patrick
'67 BJ8-Metallic Golden Beige/Red
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|