How do you in tend on cutting all those holes in the gooey Dynamat. Thats
gonna take some patience.
Sounds like it would give good heat and sound protection though.
Mark
----- Original Message -----
From: "Thomas Morrione" <tjmorrio@colby.edu>
To: "I Erbs" <eyera3@gmail.com>; "healey help" <healeys@autox.team.net>
Sent: Friday, April 23, 2010 11:33 AM
Subject: Re: [Healeys] under dash insulation pad
> On the tar paper under the dash, FWIW. I'm at the point of putting mine in
> and am taking Dave Nock's suggestion to put Dynamat behind it. Spray glue
> the tarpaper to the Dynamat after sticking it on. The Dynamat will be
> hidden
> this way -- and should look a bit less flashy.
>
> Tom
> 65BJ8
>
>
> On 4/22/10 5:52 PM, "I Erbs" <eyera3@gmail.com> wrote:
>
>> found on page 31 Nocks hard to find parts.
>> May be a simple question but here goes.....
>> does this fit behind or above the heater assembly?
>> Hard to tell just by looking/ The heater is just not coming out. The
>> screw
>> heads wii not release. have tried heat, anti-seize, hammer screw driver
>> and
>> brute force. Do not want to rip off screw heads.
>> Thanks, and Hi John, got your message
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/lapierrem@sbcglobal.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|