I had to modify dennis welch heat shield including bending, cutting and a few
#%+*^....
I will send pictures off lst to h. Morrison. If any ones wants them send me an
email
Jose
Sent from my iPad
On Apr 20, 2011, at 9:42 AM, "Shop at \" Just Brits \"" <shop@justbrits.com>
wrote:
> << I guess that is where the "slight factory bend" comes in. >>
>
> "Sounds" reasonable, Henry.
>
> << I will make the proper modifications. >>
>
> After reading LOTS of books and chatting with DMH & Geoff, I
> would strongly lean towards carbs installed and a BFSD or smallish
> crow-bar was "the adjustment" "tool of the moment" !! LOL !
>
> Ed
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/jvvmusme@yahoo.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|