Thanks for all the responses. I went back to the car this morning and
finished the installation in a couple of hours. The article on the Acmefluid
website is really helpful and as it says near the end I reckon it is
possible to change the wheel AND re-use the original trafficator without
pulling the wires all the way through. You can do it from the top end
although you will need to cut off the connectors so they pass through the
short stator tube, and then re-solder them.
As my indicators had been moved to a seperate dashboard switch by the PO I
didn't have to do anything with the remaining 3 wires, I just isolated them
and all my electrics are working fine.
I went for the brushed aluminum Boss and horn push with AH badge. I think
the result gives a very clean look. You can see it on this web page. Scroll
to the bottom of the page.
http://www.healeysix.net/mynew100six.htm
The link to the Acmefluid article is
www.acmefluid.com.au/larry/trafficator.html
Derek
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|