healeys
[Top] [All Lists]

[Healeys] Asbestos

Subject: [Healeys] Asbestos
From: 55healey at comcast.net (robert westcott)
Date: Sat, 3 Dec 2011 09:32:19 -0800
References: <CAK8B1p1baLSiFCuc0BS+Cup=Eet_j03qqS+3bJ-bN0YyavCc0g@mail.gmail.com>
Also be careful when you remove the washers and bolts that hold the  
panels to the footwell.  Mine had rusted and were caked with  
asbestos.  I had my shop vac running
right next to them as I worked them through the holes.
I replaced the screws and bolts  with 10-32 stainless ones to hold  
down the Hardie Board.
ACE hardware even had stainless fender washers that were almost  
exactly the same size as the originalwashers (only thinner).
I sprayed the old panels with clear "Chip Guard" a softer plastic  
spray and soaked them before trying to remove them.
I used this same spray on the new Hardie Board panels to seal them  
from oil and spills as well, it soaks right in.
Double bagged the nasty old stuff and dropped it off at hazardous  
waste.  I still have an extra piece of Hardie Board if anyone needs it.

Rob

On Dec 2, 2011, at 7:44 AM, Michael J Maloney wrote:
>
> I applied,much oil to the edges,cracks and mounting holes,a few days  
> before
> attempting to remove the insulating pieces.I suited up in a
> hooded,disposable,pair of coveralls,goggles, mask and disposable  
> gloves,to
> do the work.
> I used the originals to trace shapes onto Hardie Board,from Home
> Hardware.The new ones are to be mounted on my" Jule Superstucture",  
> when it
> is completed.

<Prev in Thread] Current Thread [Next in Thread>