I power my timing light with my battery charger, no confusion on polarity or
chance to ground out.
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Bob Spidell
Sent: Wednesday, January 02, 2013 10:29 PM
To: john spaur
Cc: healeys@autox.team.net
Subject: Re: [Healeys] Timing light electrical
re: "I presume ground attaches to the frame"
Yup. Connect to something unpainted, like one of the P-clips on the wiring
harness. I always use the big terminal on
the starter solenoid--the one that connects to the battery--for a power
source. Don't let the clip contact the chassis anywhere.
Also, if your timing light has a metal case it's probably 'hot;' i.e. if it
touches the chassis you'll spark (unless you have a special, 'positive
ground timing light,' which I've never seen nor heard of). Either be very
careful or wrap the case with electrical tape, or both.
Bob
On 1/2/2013 7:18 PM, john spaur wrote:
> I have an inductive timing light. The car is positive ground. I
> presume ground attaches to the frame. What point in the engine compartment
would be good to connect the negative voltage lead too? Would terminal A1 be
good?
>
> It has been a long time since I used one.
>
> John Spaur
> Electrically challenged
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
$12.75
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://autox.team.net/mailman/options/healeys/rmcgaver@rochester.rr.com
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.2805 / Virus Database: 2637/5979 - Release Date: 12/22/12
Internal Virus Database is out of date.
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|