My relatively early BN1, body #724, measures about 9 3/16". I don't
think any Hundreds had much tighter fits around the wheels.
-Roland
On Wed, 27 Feb 2013 23:05:49 -0500 (EST), you wrote:
::I need to check something. With the 100-4, there are the BN1 front
fenders,
::and the BN2 front fenders. The easiest (only?) way to tell them apart is
to
::measure the distance from the top of the wheel opening to the top of the
::fender. Here is the Austin Healey service note about it.
::http://www.acmefluid.com.au/larry/a421.jpg
::It notes that the measured distance for the BN1 is 9 1/2 inches, and 9
inches
::for the BN2. I would SWEAR it was 11 inches for the BN1 and 9 inches for
the
::BN2. I just seem to have this strongly in my memory. Am I wrong? I would
::assume that the Healey service note is correct, but, dang! :)
:: - Paul B.
::_______________________________________________
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|
