yes that's what I want to build, so now I guess I need some old ski boot
straps too :)
I have never skied. Bad knees since I was a teen ager.....
Ira Erbs
Portland, OR
_______ _______
(______ \____1960 BT7____/ _______)
(_________________________)
On Fri, Apr 19, 2013 at 12:46 PM, Michael Salter <michaelsalter@gmail.com>wrote:
> Hi Ira, That's one that I struggled with for a while!!
> Ended up using a old hub grease cap with a large neoprene washer inside as
> a seal.
> Braized a fitting (bit like an air line connector) into the center of the
> cap to hook up my very old Snap On pressure bleeder vessel.
> Then braized a pair of spring tensioning buckles from some old (very old)
> ski boots with hooks that went down the sides of the can and latched under
> the bottom. One's gotta do what one's gotta do!!!
> I've had that device for about 30 years and have used it to bleed the
> brakes on many many Healeys.
> I only need to put about 5 p.s.i. into the bleeder vessel and I can bleed
> all the brakes and the clutch in about 5 minutes..
>
> Michael S
>
>
> On Fri, Apr 19, 2013 at 3:10 PM, I Erbs <eyera3000@gmail.com> wrote:
>
>> I want to make a pressure bleeder for my hydralic fluids. Does anyone have
>> spare cap or ideas on where to source one?
>> Ira Erbs
>> Portland, OR
>> _______ _______
>> (______ \____1960 BT7____/ _______)
>> (_________________________)
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>> Suggested annual donation $12.75
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>>
>> Healeys@autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
>>
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/healeys/michaelsalter@gmail.com
>>
>>
>
>
> --
> Michael Salter
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|