Yes, they pick up the same surfaces.
Of course I meant hundredths. You have to forgive my mistake but English is
not my native language. It's important to get it real snug, otherwise it wont
work.
Magnus Karlsson
Skickat frC%n min iPhone
> 24 okt 2013 kl. 12:26 skrev Bob Haskell <rchaskell@earthlink.net>:
>
> Magnus,
>
> Does your set of cones mimic the hub/knockoff, picking up the same surfaces
on the wheel?
>
> Re: two to three hundreds of a millimeter: Assume you mean hundredths.
0.02-0.03 mm is 0.0008-0.0011 inches. Pretty snug.
>
> Cheers,
>
> Bob Haskell
> AHCA 3000 Mk I registrar
> http://www.ciahc.org/registry_3000mk1.php
>
>> On 10/24/2013 01:20 AM, Magnus Karlsson wrote:
>> Do not try to modify a hub and spinner to fit on a wheel balancer. It will
not
>> give a satisfactory result. The best way is to machine one inner and one
outer
>> cone that will fit the shaft on a particular machine. The holes in the
cones
>> need to be two to three hundreds of a millimeter larger than the shaft.
>>
>> Once I made my own set of cones I found that the Dunlop wheels made in
India
>> infact are very good, requiring only very small weights.
>>
>> Magnus Karlsson
>> BorC%s Motor Corporation AB
>> www.concourshealeys.com
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|