I've had success sealing gaskets and small leaks with high-temp
silicone. Edd China used to use some kind of blue paste, but haven't
seen any like it around here.
Bob
On 3/7/2021 4:52 PM, Stephen Hutchings via Healeys wrote:
> Hi Folks,
>
> After many years of service my old stainless exhaust system has had it, and
> Iâ??ve decided to replace it with another stainless system.
> I wonder if any of you have some tips/tricks for getting a good gas tight fit
> at the joins.
> Iâ??ve had my car for 45 years and Iâ??ve struggled many times with
> controlling fumes. Iâ??ve recently replaced the manifold gasket, made up down
> pipe gaskets out of Remflex ( a graphite exhaust gasket material that
> compresses), lengthened my old tail pipes, and carefully checked and sealed
> the firewall.
> Itâ??s become a bit of an obsession for me, so, since Iâ??m starting with a
> new system, Iâ??m hoping to see an improvement.
>
> Suggestions?
>
> Thanks,
>
> Stephen, BJ8
> _______________________________________________
>
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|