>> Occasionally, when accelerating I hear a "ping" from what i think may be the
>> rear end/axle or the U joints (?). any way to identify this sound?
>
>This may be bad U-joint's. If there is a zerk fitting in the U-jount yoke,
lube it. Be ready to R & R it.
>
you could try checking the torque settings of the half shaft nuts. the
figure is very high, something like 135 ft/lbs and can normally only be
obtained by using a 3/4 inch drive.also are they wire wheels?. if so there
could be wear on the splines.
|