Palmer, Lew (UCI) wrote:
>
> If you are wearing these out at that rate, then your clutch bearing is out
> of alignment (hits on one side first - not squarely). Also, make sure you
> have reinstalled the spring clips the right way around. If these aren't
> right, the bearing will never seat correctly.
>
> Regards,
> Lew Palmer
> lew.palmer@uci.com
> ----------
Thanks for the tip. What is the normal rate of wear for the graphite ring
release bearings. I was told 25,000 miles by a mechanic who replaced one
for me one time.
Thanks,
Glenn Stauffer
|