mgs
[Top] [All Lists]

Re: Warm Running Sprite

To: SMitch1441@aol.com
Subject: Re: Warm Running Sprite
From: Ulix Goettsch <ulix@u.washington.edu>
Date: Sun, 27 Oct 1996 01:17:55 -0800 (PST)
On Sun, 27 Oct 1996 SMitch1441@aol.com wrote:

> My '63 Sprite (1098cc) which has less than 3,000 miles on a completely
> rebuilt motor and a recently rodded out radiator runs on the warms side when
> climbing even slight grades.  The temperature gauge will climb from 180 to
> 200-210 degrees.  The engine will also begin knocking.  I recently installed
> 
> What should I try next to cure this problem?  Am I running too hot a
> thermostat?  Should I be using a 160 degree thermostat?  Are the spark plugs

If your car is running at 200-210 deg, the thermostat doesn't make any
difference.  Both thermostats are fully open at this temperature.
The 180 deg one would let your engine heat up a little faster, but under
steady state conditions, there would be no difference.
You should check your timing to be on the safe side.

> A few more questions.  Can I install the six bladed fans in the VB catalog on
> the original water pump hub and still clear the radiator?  Would this
> modification help?

I asked this same question a while ago and got an overwhelming response
that this is a very worthwhile modificaion.  I haven't done it yet.

    Ulix                                                    __/__,__          
.......................................................... (_o____o_).....
                                                           '67 Sprite


<Prev in Thread] Current Thread [Next in Thread>