Re: Metrinch tools

[barneymg@juno.com (Barney Gaylord)]

On Wed, 15 Jan 1997 08:06:18 -0500 (EST) "Thomas Wannenburg" 
<twannen@bgsm.edu> writes:

> .....  Does anyone have any experience with these tools?  Do they
really fit both standard and metric?  What is the quality like? 

They do work with slightly varying sizes of hex fittings, but they will
fit a little sloppy and therefore have a considerable amount of backlash.
 If you're trying to use them with a rachet in a confined space you're
out of luck.

Barney Gaylord
1958 MGA