Re: Bolt on Crankshaft Pulley

[Art Pfenninger <ch155@FreeNet.Buffalo.EDU>]

        Anyone know if 1 5/16 is the size of the nut on a steel wheel MGB
rear axle?
...Art

On Thu, 9 Oct 1997, Thomas James Pokrefke, III wrote:

> To the lister who was wondering what size bolt holds the pulley to the
> front of the crankshaft, the size is 1 5/16".  This is also the same
> size of the nut that holds the hub to the rear axle on wire wheel cars.
> 
> Thomas James Pokrefke, III
> 1970 MGB
> pokrefke@ocean.st.usm.edu
> http://ocean.st.usm.edu/~pokrefke
> 
>