mgs
[Top] [All Lists]

Re: Boot lid seal

To: "mgs-digest list" <mgs@autox.team.net>, <jmc987@earthlink.net>
Subject: Re: Boot lid seal
From: "Fred Pixley" <fpixley@kingston.net>
Date: Wed, 24 Feb 1999 07:50:11 -0500
>>On Mon, 22 Feb 1999 22:49:07 -0600, Tyson Sherman <mts3@ra.msstate.edu>
>>wrote:
>
>>I recently replaced the boot lid seal on my 76 B...the type where the
>>seal is on the lid.  How do I get it to close?  The original had about a
>>6" place where there was no rubber at the bottom.  Should I duplicate
>>that with the new one?
<SNIP>

>I had the same questions/problems when I replaced the seal on the boot
>lid of my 67B. I ended up installing in starting from the latch area
>(since it's the lowest point) and worked my way around clockwise. And
>while the Moss seal was the exact length match, it was too thick. The lid
>wouldn't close or latch properly. I marked the opening with chalk, closed
>the lid to mark the seal, and then took a razor blade and cut a little
>"V" channel into the seal. No more water problem, even through last
>year's EL Nino. I know it sounds a little goofy to cut up a perfectly
>good seal. But it worked for me.  Good luck.

>Joseph
>67 B Roadster

------------------------------
Why can't the new seals just fit properly?  I have this problem with new
door seals (71 BGT).  The latches are set out to their maximum yet it takes
a forceful slam to close the doors.  I doubt if the door seals can be
modified as you did on the boot seal since they seal on a flatter surface.
I don't expect any help on this as there probably is no remedy.




Fred Pixley
Napanee, Ontario, Canada



<Prev in Thread] Current Thread [Next in Thread>