I'm in the process of installing new rings on my
MGB pistons. They're 4 ring pistons from Victoria
British from about 2 years ago. The rings are
Deves from Northwest Import (both are .030" over).
The original oil control ring consisted of top and
bottom rails and a center zigzag part. The new
one does the same but has an expander in the
middle. The expander doesn't seem to fit all that
well; is it correct to install this expander on a
B?
Thanks.
--
Tyson Sherman
mts3@ra.msstate.edu
ICQ# 10494960
http://www.tecinfo.com/~tsherman
|