mgs
[Top] [All Lists]

Re: Tech/mech Overdrive Question

To: "Phil Bates" <jello@ida.net>
Subject: Re: Tech/mech Overdrive Question
From: "Dennis and Kathy Skog" <skog@whidbey.com>
Date: Fri, 24 Dec 1999 08:36:12 -0800
-----Original Message-----
From: Phil Bates <jello@ida.net>
To: mgs@autox.team.net <mgs@autox.team.net>
Date: Friday, December 24, 1999 7:21 AM
Subject: Tech/mech Overdrive Question


>I am trying to
>separate the gearbox section from the intermediate housing and OD so >that
I can dismantle it.  It is loose, but something holds them together >when
pulled to about 1 inch apart.  Anyone have knowlege of what I >didn't get
removed or loosened, >Thanks!
>Phil Bates
>Phil,
Just did the same job a few months ago.
What is keeping your overdrive on is a small spring ring that holds
the pump cam in place on the end of the transmission mainshaft. If you have
a Moss catalog , look at the early overdrive parts breakdown near or on page
24. The spring ring I'm referring to is item # 47 and the cam is item # 45
part #'s 466-655 and 466-650. In my overdrive the spring ring  groove on the
mainshaft is round but still would not easily pull off the shaft so I had to
separate the od at the brake ring in order to loosen the spring ring.  Good
Luck !!

Dennis Skog
'64 MGB angel
'66 MGB baby
'80 MGB LE shadow
'60 Jag MkI  reggie
'58 MG Magnette ZB nonameyet




<Prev in Thread] Current Thread [Next in Thread>