Word on the street is that Gonaj@aol.com said:
> Just did a complete front end on my '76 MGB this past spring, the worst was
> getting the new upper bushings between the arms on the shock. I squeezed
> them together with a "C" clamp while I used another to force the assembaly
> into place. I get out of breath just thinking about it. Again a BFH wont
> work here for the same reason.
There's a bolt in the middle of the shock arms that, once loosened, allows
you to pry the arms apart enough with a BFS or similar tool to slip in the
top of the kingpin assy without too much trouble. At least, that's how
I did it..
> It sure makes a difference once that job is done, good luck.
Amen to that!!
Skye
--
1966 MGB - GHN3L Safety Fast! __,__\__
The MGB Experience http://www.mgb.bc.ca/ (_o____o_)
|