I wonder if the same procedure would work with the rear rubber transmission
mount?
Baker
Gonaj@aol.com wrote:
> In my experience the best way to remove them is to use an arrangement with a
> "C" clamp. A BFH dosen't work because the rubber absorbs most of the force
> but with a clamp you can load it until the force is great enough to cause the
> adhesion between the parts to yeild.
> Just did a complete front end on my '76 MGB this past spring, the worst was
> getting the new upper bushings between the arms on the shock. I squeezed
> them together with a "C" clamp while I used another to force the assembaly
> into place. I get out of breath just thinking about it. Again a BFH wont
> work here for the same reason.
> It sure makes a difference once that job is done, good luck.
>
> George
|