mgs
[Top] [All Lists]

RE: wierdest starting problem. help!

To: JPGarner@UCDavis.Edu, yd3@nvc.net, mgs@autox.team.net
Subject: RE: wierdest starting problem. help!
From: Duinhoven_Hans@emc.com
Date: Mon, 29 May 2000 02:41:40 -0400
There still might be a blocked line or filter.

Hans

-----Original Message-----
From: Garner, Joseph P. [mailto:JPGarner@UCDavis.Edu]
Sent: maandag 29 mei 2000 6:39
To: 'Bullwinkle '; 'mgs@autox.team.net '
Subject: RE: wierdest starting problem. help!


Hi mysterious stranger ;-)

And thanks to everyone else who responded

thanks. This is also what i figured. I went back out ther this evening. he
wouldn't start, and this time the fuel filter was empty. I immediately
suspected the pump, so i took the cover off and cleaned the connector. The
aerth connector is missing, and the pump preseumably grounded via the body.
I have had fuel pump problems before, which gain cleared up mysteriously
with a little connector jiggling. I suspect i should put a proper ground
connection on there before i get on the freeway to drive home!

Anyway, this got the pump working, and the car started up first time. 

However the pump can't be the whole problem, because when it failed to start
earlier today, i actually checked for this fault, and saw fuel pumping into
the filter.

My best guess is a combination of a fuel pump problem, and either a vapour
lock or carb problem. I am definately unhappy about driving 140 miles back
home until i get this sorted. The 880 in oakland for instance would be a bad
place for your engine to die!

Any further ideas anyone?

You lot are great! thanks for all the advice within a couple of hours of my
posting the message.

cheers

Joe
-----Original Message-----
From: Bullwinkle
To: mgs@autox.team.net
Sent: 5/28/00 8:23 PM
Subject: Re: wierdest starting problem. help!

This is also a symptom of fuel shortage.  The fuel line may be
blocked.  When the car sits, there is enough pressure in the line
to put a little fuel into the carbs, so it will start, but it's
not getting enough to keep it running.

<Prev in Thread] Current Thread [Next in Thread>