Do you mean it won't line up fore and aft? Had just that on my 75 V8 when
the engine mounting plates were on the wrong sides. It moved the engine
forward 1/2" so both saides would not go into the same pair of holes - one
side was in the front pair and the other in the rear.
PaulH.
----- Original Message -----
From: James Schulte <schultejim@prodigy.net>
To: <Mgs@autox.team.net>
Sent: Sunday, July 15, 2001 7:54 AM
Subject: Tranny Bracket question
> ? anyone
> I installed the overdrive in my wife's 70B today. The problem is the
> bracket that supports the tranny won't line up with the hole's on one
> side of the body frame. It seems like the tranny is to far to one side
> of the bracket. I have 2 bolts in the bracket that attaches to the
> tranny and 2 bolts in the bracket on driver side into the frame of the
> body. Passenger side just won't line up. Any suggestions? The engine
> is bolted down to the engine mounts and appears all correct.
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|