Yes, Paul;
And on mine the cross-member had a front and a rear, although you couldn't
tell which way it went in until it was tried. Of course.....I had it in
backwards the first time....of course.
Dave
----- Original Message -----
From: <paul.hunt1@virgin.net>
To: "James Schulte" <schultejim@prodigy.net>; <Mgs@autox.team.net>
Sent: Thursday, July 19, 2001 4:23 PM
Subject: Re: Tranny Bracket question
> Do you mean it won't line up fore and aft? Had just that on my 75 V8 when
> the engine mounting plates were on the wrong sides. It moved the engine
> forward 1/2" so both saides would not go into the same pair of holes - one
> side was in the front pair and the other in the rear.
>
> PaulH.
>
> ----- Original Message -----
> From: James Schulte <schultejim@prodigy.net>
> To: <Mgs@autox.team.net>
> Sent: Sunday, July 15, 2001 7:54 AM
> Subject: Tranny Bracket question
>
>
> > ? anyone
> > I installed the overdrive in my wife's 70B today. The problem is the
> > bracket that supports the tranny won't line up with the hole's on one
> > side of the body frame. It seems like the tranny is to far to one side
> > of the bracket. I have 2 bolts in the bracket that attaches to the
> > tranny and 2 bolts in the bracket on driver side into the frame of the
> > body. Passenger side just won't line up. Any suggestions? The engine
> > is bolted down to the engine mounts and appears all correct.
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|