Re: Crack of Doom

[Gonaj@aol.com]

In a message dated 8/19/2001 5:21:03 PM Mountain Daylight Time, 
brown409@home.com writes:

<< 
 Weld a small piece of metal on the inside covering the crack to give it 
strength
 then fix the crack from the outside - Mine was done in 97 and it has not
 reappeared
  >>
Good advice but I would add that you should stop drill at the end of the 
crack.  About a 1/8" drill works good.

George

///
///  mgs@autox.team.net mailing list
///  (If they are dupes, this trailer may also catch them.)