mgs
[Top] [All Lists]

Re: Rear end

To: "KENNETH WARINGA" <kcwaringa@worldnet.att.net>,
Subject: Re: Rear end
From: "British Sportscar Center" <Lawrie@britcars.com>
Date: Sat, 23 Mar 2002 11:07:55 -0800
Ken,

Oops, I forgot the sway bar! Yes, that does make a simple changeover more
difficult.......

However, there is also a problem with your Plan B. Unlike a "banjo" axle,
where the whole differential comes out as a unit (the "pumpkin"), the pinion
in a Salisbury axle stays in the case when you remove the differential gears
through the hole in the back. The inter-relation between the ring gear (on
the diff unit) and the pinion is critical. Simply changing the diff from one
axle to another might give major differences in clearance which would
result, at least, in a very noisy rear end or, at worst, gears that mesh so
tightly they tear the teeth off each other in a fairly short time.

So, the best option for you is to use the '74 axle complete but to cut the
swaybar brackets off the '79 axle housing and weld them onto the '74.

Lawrie
BSC
----- Original Message -----
From: "KENNETH WARINGA" <kcwaringa@worldnet.att.net>
To: "MGs" <mgs@autox.team.net>
Sent: Saturday, March 23, 2002 10:49 AM
Subject: Re: Rear end


> I finally got out there and looked at the 2 cars and have pretty much
> decided if I can get the differential out that's what I'm going to do.
The
> housing in the 79 is different than the earlier model in that the late one
> has a sway bar and the early one doesn't.  Now all I need to do is figure
> out how to get the differential out without the special tool shown in the
> manual.
>
> Ken

///
///  mgs@autox.team.net mailing list
///  or try http://www.team.net/cgi-bin/majorcool
///


<Prev in Thread] Current Thread [Next in Thread>