Not quite sure what the meaning of your 'not too surprising' is but the
front hub nuts are supposed to be torqued to between 40 and 70 ft lbs. The
wide 'tolerance' is to allow one of the split pin holes to be lined up. The
rears are 150 ft lbs and to the next hole.
----- Original Message -----
From: "Andrew B. Lundgren" <lundgren@byu.net>
To: "MG List" <mgs@autox.team.net>
Sent: Thursday, September 12, 2002 4:27 AM
Subject: Never under estimate your DPO. (If you had one...)
> Strange I thought. I pulled the pin out and found the nut loose. (Not
> finger tight, loose.) Not too suprising, that is how the on front one
> was, but the pin was in correctly....
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|