mgs
[Top] [All Lists]

Re: commission no. plate

To: David Councill <dcouncil@imt.net>, mgs@autox.team.net
Subject: Re: commission no. plate
From: Barrie Robinson <barrier@bconnex.net>
Date: Sun, 11 Apr 2004 12:14:48 -0700
David,

I have the same dilemma.  I have been told by my shop chap that one can buy 
the stamps for about $20 which is cheaper than sending them away to be done.

I have not looked for the stamps but I will now that you have the same 
need.  If you find a good solution please let me know.


At 04:48 PM 4/10/2004, David Councill wrote:
>For so many years, I drove rusted out MG Bs and BGTs. Maybe once every few 
>years, I'd run a screwdriver through the holes in my rocker panels to 
>remove a few pounds of rust and sand particles that had accumulated. And 
>there was seldom a need to wash my cars - I'd just make the rust look 
>worse. Now I'm older and not as poor. I've upgraded to better looking and 
>less rusty MGs. I even went so far as to almost completely restore my 72B 
>from body shell up. That means I have to wash it and fret over the small 
>water stains that glisten on the shiny black tulip finish.
>
>As the restoration nears completion, I work on cosmetics. This weekend, I 
>removed the commission number plate which had been painted over at least 
>twice with green and black tulip (the car originally being orange, better 
>known as "blaze red"). My paint remover effectively removed the paint, 
>literally all of it, off the plate. I have a shiny plate but the numbers 
>are now readable. But that let me know that I would need to order another 
>plate, readily available and cheap from Moss. So the question is where do 
>I get the numbers pressed in to the plate? I remember some place was 
>mentioned on this list not too long ago. So I just need contact 
>information at minimum (USA if possible) although I have other questions 
>on quality of work, duplication of the type sort of stuff.
>
>David Councill
>67 BGT
>72 B
>

Regards
Barrie

Barrie Robinson
barrier@bconnex.net 





<Prev in Thread] Current Thread [Next in Thread>