I briefly had a motor on a stand for teardown once. I used some of the
bellhousing bolt holes. This stand had long standoffs on adjustable arms --
it was easy enough to tell how long the bolts needed to be by measuring the
standoff tubes -- just pick the hole locations and match the existing bolt
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
on 10/13/09 7:14 AM, W. David Houser at firstname.lastname@example.org wrote:
> Want to start rebuilding a 74 MGB engine that I have and bought an
> engine stand from Harbor Freight(I know).
> What size long bolts do I need to secure the engine to the tripod
> rolling stand? Where do I bolt it to?
> Who's been here already and can shed some tips?
> Dave Houser
Support Team.Net http://www.team.net/donate.html